Filter
Top Products
Model 500/600
3-16. LIMIT STOP
ADJUSTMENT
To extend the life of the lid gasket and help prevent steam
leakage, check the limit stop adjustment quarterly, following the
steps below.
1. Close and latch lid, and turn spindle counterclockwise until
it stops.
2. Using a 3/16” Allen wrench, loosen the 2 set screws on the
outer collar of the limit stop.
3. Turn the inner collar clockwise until it stops.
Insert a small screwdriver or Allen wrench in the hole in the
inner collar to assist you in turning the collar.
4. Turn spindle clockwise until it stops. The lid gasket is now
touching the frypot rim.
5. From the front of the fryer, turn the spindle at least 3/4 of a
turn, but not over 1 turn. One of the spindle arms should be
lined up with the red ball of the latch, at this time.
6. Slightly turn the spindle past this position, so it should show in
about the 7 o’clock position.
The 7 o’clock position is only to allow slight additional turning
of the spindle to relieve any side pressure against the locking
pin. Side pressure holds the pin in the locked position, even
after all the pressure has released.
When adjustment is complete, if a black ball on the spindle is
lined up with the red ball on the latch, unscrew the black ball
and the red ball on the spindle and change places on the
spindle. The red ball on the spindle should now line up with
the red ball on the latch.
Step 2
Step 3
1207 3-29