Filter
Top Products
Model 500/600
To extend the life of the temperature probe, high limit, and elements,
every 90 days check the tightness of the element spreader bar screws,
following the steps below:
Drain shortening and allow fryer to cool before proceed-
ing with the following steps. Surfaces of the fryer will be
hot and burns could result.
1. Check that all spreader bars are in place (4 sets), and using a
5/16” socket or wrench, tighten all the element spreader
screws.
If the bolts or spreaders are missing or damaged, order
kit no. 14685 from your nearest Henny Penny distributor.
2. Pump shortening back into frypot and unit is now ready for
use.
3-18. CHECK & TIGHTEN
ELEMENT SPREADER
BARS (Model 500 only)
1207 3-31