Filter
Top Products
Program chart
Program When to use Detergent
containing
chlorine
1)
chlorine
free
2)
Compart-
ment
I
(Pre-wash)
Compart-
ment
II
(Wash
cycle)
Compart-
ment
II
(Wash
cycle)
Program
NORMAL
55 °C/130 °F
This program is for normal everyday loads. 20 % 80% 100 %
NORMAL
65 °C/150 °F
Same as NORMAL 55 °C/130 °F, but at a
higher temperature. Use for stubborn
dried on particles.
20 % 80 % 100 %
INTENSIVE
55 °C/130 °F
Contains an additional pre-wash cycle.
Use for heavily soiled dishes.
20 % 80 % 100 %
INTENSIVE
65 °C/150 °F
Same as INTENSIVE 55 °C/130 °F, but at a
higher temperature. Use for stubborn dried
on particles and lightly soiled pots and
pans.
20 % 80 % 100 %
Special programs
ECONOMY
55 °C/130 °F
For a half sized load, or for a full load with
very light soiling (e.g. coffee cups). 50 %
3)
50 %
3)
RINSE & HOLD
For rinsing dishes if a complete program is
not yet needed.
The dispensing method will depend on the type of detergent being used:
1) Use this ratio for:
– detergents which contain phosphates and chlorine
Divide the total amount, as shown, between compartment I and compartment II.
2) Use this ratio for:
– detergent which is chlorine and phosphate free
– detergent which is chlorine free but contains phosphates
In this instance the whole amount is placed in compartment II.
3) Use half of your normal amount of detergent.
For the NORMAL and INTENSIVE programs, one to two tablespoons of detergent is usually sufficient
for excellent wash results.
Program chart
30