Filter
Top Products
If the adjacent cabinetry (or ap-
pliance) does not have drawers and
alignment to a drawer line is im-
possible:
Hang the bracket on the machine
door, without the templates, and
tighten the four locking screws on
the edges of the door panel.
Close the door.
Measure the distance from the ad-
jacent cabinet (or appliance) door
bottom to the bottom of the mounting
bracket (X).
Using measurement (X), draw a line
on the rear of the door panel (X) in-
ches up from the bottom.
Remove the bracket from the ma-
chine door and place it on the rear of
the door panel so that:
– the bracket is centered left to right,
and
– the bottom of the bracket is aligned
with the (X) line.
Tape the bracket to the door panel to
hold it in place while the mounting
holes are being drilled.
Drill pilot holes for the screws using a
3/32" (2.5 mm) bit.
Attach the bracket to the panel using
the 6 screws provided.
Remove the templates (if used).
The templates should be kept in case
you want to install a different door
panel on the dishwasher at a later date.
Attach the panel to the dishwasher
by aligning the bracket tabs with the
slots on the door.
Dishwasher installation
53