Filter
Top Products
Administrative Tasks
601354 Rev A Normal Operations 4-29
Normal Operation
• The target archive must be configured with the auto
check-in and auto import options selected. If not, all the
subject media are left in the load port and a failure message
is logged and displayed at the Volume Server System
console.
• The auto import destination media class (set up during
archive configuration) must have a capacity low enough to
allow addition of more media. Excess media are left in the
load port and a failure message is logged and displayed at
the Volume Server System console.
Destination media class capacity - Fill level = Amount of media that can be entered
• The receiving archive media class fill level must be low
enough to allow addition of more media. Excess media are
left in the load port and a failure message is logged and
displayed at the Volume Server System console.
Archive media class capacity - Fill level = Amount of media that can be entered
Enter Known
Media into an
Archive
All media can be classified as known or unknown. Unknown
media were never introduced into a VolServ system or were
removed using the Export Media command. Known media are
contained in an archive, are checked out using the Check-out
Media command, or are intransit to another archive as a result
of a Move Media command, Mount Media command, or media
migration.
Two basic ways to reenter known media into an archive are: the
Check-in Media command and the unsolicited enter and
AutoEnter methods.