Filter
Top Products
Administrative Tasks
3-22 Initial Configuration 601354 Rev A
Mountable By
Class
Selecting the mountable by class option sets a flag for the
subject Media Class. This flag is used by the Mount Media
command.
The Mount Media command provides four ways in which
media may be selected for mounting. These are:
• Mount by media identifier
• Mount by media list
• Mount by media class
• Mount by criteria
VolServ software supports the mount by media class method
for the subject Media Class only if the mountable by class
option is selected. When not selected, the Mount Media
command cannot use the mount by media class option for the
subject Media Class. Refer to “Mount Media on a Drive” on
page 4-18 for more information.
High Mark
Notification
The media class high mark indicates a capacity break point that
is calculated as a percentage of class capacity. After the high
mark capacity is reached, a notification is logged and displayed
on the Volume Server SysLog Console.
When entered, a notification comment accompanies the syslog
message. The syslog message occurs each time media are added
to the media class. No more media may be entered into the
media class when class capacity is reached, regardless of which
archive it is associated with.
Note
The notification is displayed at the “alert” level in the system log.