Filter
Top Products
4. ClickShare installation
4.6 Video signal connections to the Base Unit
CAUTION: M ake sure the Base Unit is installed properly before connecting.
About Video signal connection
Depending on the local setup, a single screen or dual screen set up is possible.
For a single screen s etup, a DVI or DisplayPort connection should b e make between the Base Unit and the display.
For a dual screen setup, a DVI and a DisplayPor t con nection
To connect
1. Connect the Base Unit to the display(s) using display cables.
Refer to “1” on image 4-6.
1
Image 4-6
Display cables connection
Note: Display cables are not included in the ClickShare box at purchase.
Supported types of displays are:
- Single Link DVI
-DisplayPort
- VGA: use the adapter included in the ClickShare box (reduced blanking on highest resolution)
- HDMI: use an adapter cable (not included in the box)
Whe n setting up a single display configuration, connect the DVI-I or the DisplayPort cable to the display.
When setting up a dual display configuration, connect the DVI-I connec tor with display 1 and the DisplayPort connector with
display 2.
R5900004 CLICKSHARE 28/03/2013
23