Filter
Top Products
5. Preparing the buttons
Both the LEDs of the Button and the L EDs of the Base Unit are blinking white. This means pairing is in progress.
The Base Unit automatically checks whether the software of the Button is up to date. If not, the Base Unit updates the B utton
software. This may take more time.
During the pairing and update process, a message is displayed on the screen: “P airing and updating B utton. B usy pairing and
updating”
Image 5-2
Pairing mes s age
The result of the pairing process can be as follow:
- When the LEDs become static white, the Button is paired to the Base Unit, but no software update was needed. You can
unplug the Button from the Base Unit.
- When the LEDs become static red, the Button is paired to the Base Unit and the software update has finished. You can unplug
the Button from the Base Unit.
Image 5-3
Pairing finishec
2. Unplug the Button from the Base Unit.
Image 5-4
Unplug Button from Base Unit
The Button is now ready for use.
5.2 Pre-install of the Launcher service
Launcher service pre-install
The ClickShar e Launcher service can be pre-installed on your laptop or on company le vel. How this is done depends on your IT
infrastructure.
When the Launcher service is pre-installed, a launcher application runs in the background. When you plug the Button in your la ptop,
the ClickShare application will be run from th e Button automatically. There is no need to run the fi le from the Button.
The pre-installer c an be downloaded from the Barco website or from the Button mass storage drive in the folder Launcher service.
32
R5900004 CLICKSHARE 28/03/2013