Filter
Top Products
5. Preparing the buttons
5. PREPAR IN G TH E BUTTONS
Overview
• Pairing
• Pre-install of the Launcher service
5.1 Pairing
Pairing of the Buttons to the Base Unit
To be able to use a Button it should be assigned to the Base Unit you are using. This process is called pairing. By default, the four
Buttons delivered in the ClickShare set are already paire d to the specific Base Unit.
In case you buy additional Buttons or when a Button should be assigned to another Base Unit, the But
ton needs to be paired (again).
When updating the Base Unit software, it is advised to also pair your Buttons with the Base Unit to update their software.
A Button can only be paired to o ne Base Unit at a tim e.
The Bu tton will alway s make connection to the Base Unit it was last p aired to.
To pair a Button to the Base Unit
1. Insert the Button in the USB port at the front of the Base Unit you are using.
Image 5-1
Inserting Button into the Base Unit
R5900004 CLICKSHARE 28/03/2013 31