Filter
Top Products
Using the System Utilities
Using the EISA Configuration Utility
NCR S10XL Hot Plug Server User Guide 5-17
2.
Select System, then Print to print a list of the
resources.
3.
Select View, then Switch, and Jumper Settings to see
how to change the switch and jumper settings.
Make a note of the information.
4.
Exit from the utility.
5.
Turn off the system and set the jumpers and
switches.
If you have locked the board configuration using Edit
and Lock commands, you need to unlock the
configuration to make all resources available to the
ECU.
To unlock the configuration, follow these steps:
1.
Select Edit, and then Unlock to unlock either the
entire system or the current board. The current
board is highlighted.
2.
Select OK.
3.
Select System, then Verify.
Starting the ECU From a Fixed Disk
Although we recommend that you start this utility from
the System Configuration diskette, you can start the
utility from your fixed disk if you have MS-DOS
installed on it.
Options