Filter
Top Products
Sample Configurations
Sample Standard Configuration
C-8 NCR S10XL Hot Plug Server User Guide
After configuring the System Settings and PCI Adapter
settings using the BIOS Setup Utility, the system
reboots.
To configure the SCSI adapters and drivers, if connected
to an Adaptec SCSI adapter, follow these steps:
1.
Press [Control] + [A] when the following displays:
Adaptec AIC-7870 BIOS v1.2
<<Press hot key for SCSI Select (TM)
Utility>>
(Refer to the Adaptec SCSI documentation for
additional information about these settings).
2.
Select SCSI Disk Utilities. Observe that the 2 GB disk
drive and the CD-ROM drive are displayed with the
correct information. If a low-level format on the 2
GB disk drive is needed, perform it now. It is
usually not needed.
3.
Select Configure/View Host Adapter Settings and
set the parameters as follows:
SCSI Bus Interface Definitions
Host Adapter SCSI ID [7]
SCSI Parity Checking [Enabled]
Host Adapter SCSI Term [Low ON/High
ON]
Boot Device Options:
Boot Target ID [0]
Boot LUN Number [0]
Configuring the SCSI
Adapters and Drives