Filter
Top Products
Sample Configurations
Sample RAID Configuration
C-20 NCR S10XL Hot Plug Server User Guide
4.
Go back into the BIOS Setup Utility, and re-enable
the PCI adapters.
To configure memory and other baseboard settings,
follow these steps:
1.
Insert the EISA Configuration Utility in the diskette
drive. Observe that the EISA Configuration Utility
boots properly.
2.
Select M5 from the Advanced Configuration menu.
Refer to Chapter 5 for instructions on
configuring the memory correctly.
The PCI Adapter IRQ values entered below do not
set the IRQ level for PCI Adapters.
PCI Adapter IRQ settings are set in the BIOS Setup
Utility. You enter the IRQ settings in the EISA
Configuration Utility so that the EISA Configuration
Utility does not assign IRQ values to EISA Adapters
that have already been used for PCI Adapters.
Make sure the parallel port and serial ports are
configured the same way as in the BIOS Setup
Utility.
3.
Configure the baseboard options as follows:
System Memory Function
Base System Memory [640 K Base Mem]
4-16 MB Ext Memory [16 MB Ext Mem...]
16-64 MB Ext Memory [Ctrl-R to add...]
PCI Devices IRQ assignment
On board 7870 SCSI
controller
[Disabled]
Note: