Filter
Top Products
Hot Plug Backplane
Installation
NCR S10XL Hot Plug Server User Guide D-9
Installation
This section describes the hot plug backplane
installation procedures.
If your system board has onboard SCSI connectors, you
may connect them directly to the backplane channels
using SCSI cables.
To install the backplane when you are using the SCSI
connectors on the system board, follow these steps:
1. Set the terminator switches on the backplane
according to your planned SCSI channel
configuration. Refer to the “SCSI Channel
Configurations” section earlier in this appendix for
the channel configurations.
2. Define the SCSI drive IDs by setting the SCSI ID
jumpers on the hard disk drive.
3. Remove all the old hard disk drive trays from the
system, if any.
4. Install the backplane and secure it with eight screws.
Using the System
Board SCSI
Connectors