Filter
Top Products
Sample Configurations
Sample Standard Configuration
NCR S10XL Hot Plug Server User Guide C-11
3.
Configure the baseboard options as follows:
System Memory Function
Base System Memory [640K Base Mem]
4-16 MB Ext Memory [16MB Ext Mem...]
16-64 MB Ext Memory [Ctrl-R to add...]
PCI Devices IRQ
assignment
On board 7870 SCSI
controller
[Disabled]
PCI slot 1 [Disabled]*
PCI slot 2 [Disabled]*
PCI slot 3 [Disabled]*
System BIOS Type [E, F Segment...]
Peripheral Device Status
Mouse Port [Enabled]
Keyboard Port [Enabled]
Floppy Disk Controller [Enabled]
IDE HDD Interface [Disabled]
Parallel Port [Enabled as LPT1...]
Serial Port 1 [Enabled as Serial 1...]
Serial Port 2 [Enabled as Serial 2...]
System Setting
Special System Ports [Enabled]
EISA Reserved Device [Enabled]
If a PCI adapter is configured in the system,
change Disabled to the IRQ level for the PCI adapter
installed in the slot.
4.
Exit and save the configuration.
At this point the server is setup, configured, and ready
for the operating system.
*Note: