Filter
Top Products
Sample Configurations
Sample RAID Configuration
NCR S10XL Hot Plug Server User Guide C-17
• Set the On Board SCSI to IRQ 11.
• Set the VGA Palette Snoop to Disabled.
• Set the On Board SCSI AIC-7870 to Enabled.
• Set the Boot Drive to Enabled.
When you finish, the screen should look like the
following:
PCI IRQ Setting [Manual]
INTA INTB INTC INTD
PCI Slot 1 [ 5] [ 14] [15] [11]
PCI Slot 2 [ 14] [15] [11] [ 5]
PCI Slot 3 [15] [11] [ 5] [14]
On Board SCSI [11] [ 5] [ 14] [15]
VGA Palette Snoop [Disabled]
On Board SCSI AIC-7870 [Enabled]
Boot Device [Enabled]
4.
Press [Esc] to return to the main menu in BIOS
Setup.
5.
Press [Esc] again. Select Yes to save System Settings
and PCI Adapter settings and to reboot the system.
After configuring the System Settings and PCI Adapter
settings using the BIOS Setup Utility, the system
reboots.
To configure the SCSI adapters and drivers, if connected
to an Adaptec SCSI adapter, follow these steps:
1.
Press [Control] + [A] when the following displays:
Configuring the SCSI
Adapters and Drives