Filter
Top Products
Hot Plug Backplane
Using the Hot Plug Feature
NCR S10XL Hot Plug Server User Guide D-15
Using the Hot Plug Feature
The faulty drive indicator on the hot plug drive tray
lights up whenever the drive that it carries becomes bad
or defective. When this happens, you can replace the
defective drive without shutting off the system or
quitting any running application by using the hot plug
feature.
To use the hot plug feature, follow these steps:
1. Set the hot plug drive tray power switch to the
Unlock/Power Off position.
2. Pull out the drive tray.
3. Take out the defective drive from the tray.
4. Configure the new hard disk. Make sure that the
new drive ID is the same as the old drive ID.
5. Install the new disk according to the installation
steps in the “Installation” section of this appendix.
Make sure that the power switch on the
drive tray is set to the Unlock/Power Off position
before you plug it to the backplane board.
Note: