Filter
Top Products
Configuring the System Board
Installing SIMMs
NCR S10XL Hot Plug Server User Guide 2-9
Installing SIMMs
Read the ESD precautions section earlier in this chapter
before proceeding.
To install a SIMM, follow these steps:
1.
Slip a SIMM at a 45
o
angle into a socket with the
component side facing down.
2.
Gently press the SIMM up until the pegs of the
socket slip into the holes on the SIMM and the
holding clips lock the SIMM into position.
The SIMM should be at a 90
o
angle when
installed on the baseboard or the dual processor
CPU board. The SIMM should be at a 45
o
angle
when installed on the ECC uni-processor CPU
board.
45°
Caution
Note:
Figure 2-2
Installing a SIMM