Filter
Top Products
Sample Configurations
Sample Standard Configuration
NCR S10XL Hot Plug Server User Guide C-3
3.
Install the SCSI CD-ROM drive in the top front
drive bay.
4.
Connect power cables and SCSI cables to the SCSI
CD-ROM drive. A Fast/Wide SCSI cable should
already be connected from the Adaptec controller on
the baseboard to the hot plug backplane.
5. Install the memory SIMMs in bank 1 on the system
baseboard (installed in groups of two SIMMs).
6.
Install the PCI Ethernet Adapter in PCI slot 1
(topmost PCI slot).
7.
Install the PCI Token Ring Adapter in PCI slot 2
(below the PCI Ethernet adapter).
8.
Install the ISA Video Board in EISA/ISA slot 2
(second EISA/ISA slot from the top).
To configure the system settings in the BIOS Setup
Utility, follow these steps:
1.
Turn on power to the system. Observe that the
memory test is executed (memory addresses should
be rapidly displayed in upper left-hand corner of
screen). Ignore any memory size mismatch error
displayed on the screen.
2.
Press [Control] + [Alt] + [Esc] when prompted to
enter the BIOS Setup Utility.
3.
Select Load System Defaults and press [Enter].
Configuring the
System Settings