Filter
Top Products
Scheduled Maintenance
Establish a regular maintenance schedule based on the actual machine requirements such
as machine load, run hours, and water quality. The time intervals listed in this section are
offered as guides to service only.
Service Ontime
The LID will display a
SERVICE ONTIME
value on the Status01 table. This value should be
reset to zero by the service person or the operator each time major service work is completed
so that time between service can be viewed.
Inspect the Control Center
Maintenance is limited to general cleaning and tightening of connections. Vacuum the
cabinet to eliminate dust build-up. In the event of machine control malfunctions, refer to the
Troubleshooting Guide section for control checks and adjustments.
CAUTION
CAUTION
!
Be sure power to the control center is off when cleaning and tightening connec-
tions inside the control center.