Filter
Top Products
23
326142000
Make sure CO
2
cylinder shutoff valve is fully opened and regulator assembly 1800-psi gage indicator is not in
shaded (‘‘change CO
2
cylinder’’) portion of dial. If so, CO
2
cylinder is almost empty and must be replaced as
instructed.
CLEANING AND SANITIZING
DAILY CLEANING
Daily; or more often if necessary, wash all external surfaces of Unit, rinse with clean water, then wipe dry with
clean soft cloth. DO NOT USE ABRASIVE CLEANERS. Remove and wash drip tray and cup rest with warm
water and mild detergent, rinse with clean water, then install them on Unit.
SANITIZING
The Unit should be sanitized as instructed every 90 days and before and after storage periods following parent
company requirements and sanitizer manufacturers recommendations.
CLEANING CONDENSER COIL
NOTE: Circulating air, required to cool the refrigeration system condenser coil (see Figure 6), is drawn in
through louvers on front and exhausted out through louvers on sides and back of Unit. Restricting air circulation
through the Unit will decrease its cooling efficiency. Condenser coil must be cleaned periodically as instructed.
LUBRICATION
Carbonator pump motor must be lubricated as instructed.
ADJUSTMENTS
CARBONATED WATER FLOW RATE
The black carbonated water flow regulators (see Figure 2 and 6), which control carbonated water flow rate into
product blender tanks, are factory adjusted and normally do not require further adjustment. If adjustment should
become necessary, adjust as instructed.
CO
2
REGULATORS
Primary CO
2
Regulator.
The primary CO
2
(see Figure 2) regulator regulates CO
2
pressure to soft drink tanks (also to bag-in-box syrup
system if used) and secondary CO
2
regulators located inside Unit. If necessary to adjust primary CO
2
regulator,
adjust as instructed.
Secondary CO
2
Regulators.
The secondary CO
2
regulators (see Figures 2 and 6) regulate CO
2
pressure to carbonator and product blender
tanks. If necessary to adjust secondary CO
2
regulators, adjust as instructed.
ADJUSTING BEATERS MOTORS CURRENTS
Beaters motors currents must be adjusted as instructed in SERVICE AND MAINTENANCE SECTION.