Filter
Top Products
24326142000
PROGRAMMING MAIN MENU SELECTIONS ONTO MESSAGE DISPLAY
The MAIN MENU SELECTIONS (see Table 4) may be brought up on message display as instructed in
SERVICE AND MAINTENANCE SECTION.
SETTING ‘‘CLOCK’’ (TIME OF DAY)
NOTE: ‘‘CLOCK’’ (TIME OF DAY) must be programmed into Unit before ‘‘DEFROST’’ (AUTOMATIC),
‘‘SLEEP’’ (SLEEP TIME), and ‘‘WAKE UP’’ (WAKE UP TIME) can be programmed into the Unit.
Program ‘‘CLOCK’’ (TIME OF DAY) into Unit as instructed in SERVICE AND MAINTENANCE SECTION.
PROGRAMMING ‘‘DEFROST’’ (AUTOMATIC) SETTINGS INTO UNIT
The automatic defrost system may be programmed into the Unit to occur up to nine different times during a day
with a minimum of two hours between defrost time settings. Program automatic defrost time settings into the
Unit as instructed in SERVICE AND MAINTENANCE SECTION.
PROGRAMMING ‘‘SLEEP’’ (SLEEP TIME) INTO UNIT
‘‘SLEEP’’ (SLEEP TIME) may be programmed into Unit to occur any time of the day after the Unit automatic
defrost cycle has occurred. Unit will shut down (go into sleep time) and will not wake up (return to normal
operation) until programmed ‘‘WAKE UP’’ (WAKE UP TIME) has occurred. Program ‘‘SLEEP’’ (SLEEP TIME)
into Unit as instructed in SERVICE AND MAINTENANCE SECTION.
PROGRAMMING ‘‘WAKE UP’’ (WAKE UP) TIME INTO UNIT
‘‘WAKE UP’’ (WAKE UP TIME) May be programmed into Unit to occur any time of the day to wake Unit up
(return to normal operation) after‘‘sleep time’’ has occurred. Program ‘‘WAKE UP’’ into Unit as instructed in
SERVICE AND MAINTENANCE SECTION.
PROGRAMMING POINT OF SALE MESSAGE DISPLAY
Three point of sale display messages are available to choose from and may be programmed into Unit by placing
No. 1, No. 2, and No. 3 switches on DIP SWITCH assembly on master circuit board in appropriate positions.
Program point of sale display messages into Unit as instructed in SERVICE AND MAINTENANCE SECTION.
ADJUSTING ‘‘VIS SET’’ (PRODUCT VISCOSITY) OF DISPENSED PRODUCT
Adjusting ‘‘VIS SET’’ (PRODUCT VISCOSITY) determines what product consistency of the dispensed product
will be present in each freeze cylinder. Adjust ‘‘VIS SET’’ (PRODUCT VISCOSITY) of the dispensed product as
instructed in SERVICE AND MAINTENANCE SECTION.
DISPLAYED EVAPORATOR REFRIGERATION COILS INLETS AND COMMON OUTLET
SENSORS TEMPERATURES
Evaporator refrigeration coils inlet and common outlet temperature readings in degrees Fahrenheit may be
displayed on message display as instructed in SERVICE AND MAINTENANCE SECTION