Filter
Top Products
66326142000
Trouble RemedyProbable Cause
FROZEN PRODUCT
CONSISTENCY VARIES
EXCESSIVELY.
A. Dispensed product BRIX
varying because:
A.
Syrup and/or water flow
regulator sticking.
a.Clean regulator(s).
Primary CO
2
regulator pressure
insufficient.
b.Primary CO
2
regulator must be
adjusted from 80 to 100-psi.
B. Cylinder freeze–up causing ice
formation in center of cylinder
and liquid product channels
around ice formation.
B. Refer to CYLINDER
FREEZE–UP.
NOTE: DEFROST AFFECTED FREEZE CYLINDER AS
INSTRUCTED.
CYLINDER FREEZE–UP. A. Dispensed product BRIX too
low.
A. Refer to BRIX (Water-to-Syrup)
‘‘Ratio’’ too low.
B. Viscosity of dispensed product
not properly adjusted.
B. Adjust dispensed product
viscosity as instructed
ACCESSORIES AND TOOLS
ACCESSORIES
1155 Installation Kit
511005000 Cup Holder
511006000 Cup Holder
511035000 CO
2
Changeover Kit
1040 Seal Kit, Rear O–Ring Housing and O-Rings
GENERIC FLAVOR TABS
1085 Cola
1086 Cherry
1087 Orange
1088 Grape
1089 Lemon–Lime
1090 Strawberry
1091 Banana
SERVICE TOOLS
151689000 Spanner Wrench, Flow Regulator
281884000 3-gallon Sanitizing Tank
322859000 Spanner Wrench, Dispensing Valve
511004000 Refractometer, 0–30 Scale
322063000 Shaft Seal Assembly Puller
0726 Alignment Tool Kit, Beater Drive Shaft Ass’y