Filter
Top Products
41 326142000
PROGRAMMING POINT OF SALE MESSAGE DISPLAY
(see Figure 7 and 10)
Note: Point of sales display messages may be turned off by placing No. 1 and No. 3 switches on master
circuit board (see Figure 10 and Tables 5 and 7) assembly in appropriate positions.
Three point of sales display messages are available to choose from and may be programmed by placing switch
No. 1 No. 2 and No. 3 on DIP SWITCH assembly on master circuit board in appropriate positions. See Figure
10 and Tables 5 and 7 and program desired point of sales display message which will be displayed on message
display.
ADJUSTING “VIS SET” (PRODUCT VISCOSITY) OF DISPENSED PRODUCT
Adjusting “VIS SET” (PRODUCT VISCOSITY) determines what product consistency of the dispensed product
will be present in each freeze cylinder. Adjust “VIS SET” (PRODUCT VISCOSITY) of the dispensed product as
follows.
1. Refer to PROGRAMMING MAIN MENU SELECTIONS INTO MESSAGE DISPLAY and bring up “VIS
SET” on message display.
2. Press “DEFROST” (SELECT) switch to bring up numbers on message display.
Note: The direction of arrows (% &) on message display indicates which set of numbers belongs to
which freeze cylinder. A No. 4 setting indicates the thinnest product consistency of dispensed product
and a No. 12 setting indicates the thickest consistency of product dispensed.
3. Press “CANCEL DEFROST” (ADVANCE) switch. The left-side freeze cylinder viscosity number will be
flashing on message display.
4. Press ‘‘CANCEL DEFROST’’ (ADVANCE) switch to advance viscosity number to desired setting. Press
‘‘DEFROST’’ (SELECT) switch to lock in viscosity setting. The right-side freeze cylinder viscosity number
will now be flashing.
5. Press ‘‘CANCEL DEFROST’’ (ADVANCE) switch to advance viscosity number to desired setting. Press
‘‘DEFROST’’ (SELECT) switch to lock in viscosity setting.
6. Press ‘‘ERROR RESET’’ switch two times to exit from MENU SELECTIONS.
‘‘VIS READ’’ (ACTUAL VISCOSITY READOUT) OF PRODUCT IN FREEZE CYLINDERS
‘‘VIS READ’’ (ACTUAL VISCOSITY READOUT) may be brought up on message display to actually read the
viscosity (product consistency) of the product in the freeze cylinders while the Unit is in operation. Bring ‘‘VIS
READ’’ up on message display as follows:
1. Refer to PROGRAMMING MENU SELECTIONS ON MESSAGE DISPLAY and bring up ‘‘VIS READ’’ of
product in freeze cylinders.
2. Press ‘‘DEFROST’’ (SELECT) switch to bring up actual viscosity readout of product in each freeze cylinder.
3. Press ‘‘ERROR RESET’’ switch two times to exit from MENU SELECTIONS.
DISPLAYED EVAPORATOR REFRIGERATION COILS INLETS AND COMMON OUTLET
SENSORS TEMPERATURES.
Evaporator refrigeration coils inlet and common outlet temperature readings in degrees Fahrenheit may be
displayed on message displays as follows: