Filter
Top Products
24
When programming you can either use one of
the existing menus or you can start from
scratch
by simply pressing the BOOK icon ( ) and
following steps 3 to 5 below.
1. Before you start programming your own
recipe, select from one of the existing
menu’s from (1) to (8). This will be the
basis of your new recipe.
Simply press the MENU button to cycle
through the menus.
Note: Refer to the Time cycle chart on
page 74, so you can choose the most
appropriate menu.
2. To commence programming press the
MODIFY button for 2 seconds.
The control panel will beep once, the
BOOK icon ( ) will show on the
LCD window and the first stage of the
breadmaking cycle - Preheat ( ) will
flash.
3. To adjust times press the +/- (
▼/▲)
buttons. When you have selected the
desired time, press the MODIFY button to
move to the next stage of the breadmaking
cycle.
Then press the +/- (
▼/▲) buttons again to
select your desired times. Repeat this until
all times have been entered.
Note: The process is completed when a
longer double beep is heard, the BOOK
icon ( ) will flash and the total
breadmaking cycle time is displayed.
Note: Don’t forget, you can use the Quick
Reference Help Cards as a reminder.
4. Once you have finished programming, you
can either save your recipe now, by simply
pressing the SAVE button, the BOOK icon
( ) will stop flashing and the control
panel will beep 3 times.
Your recipe has now been saved into one of
the 8 Favourite Recipe slots.
OR
You can test your recipe first, without yet
saving it by simply pressing START. If you
then want to save the recipe you must ensure
that you press SAVE before the end of the
KEEP WARM ( ) mode.
Note: You can not save the recipe once the
Keep Warm cycle is complete.
5. To cancel the programming process at any
stage simple press the CANCEL button.
Reprogramming a Favourite Recipe
You can make changes to, or replace any of
your saved Favourite Recipes at any time.
1. Select the recipe you wish to modify by
pressing the book icon ( ) button.
This will allow you to scroll through
Favourite Recipes
(1) to (8).
2. To commence programming press the
MODIFY button for 2 seconds.
The control panel will beep once and the first
stage of the breadmaking cycle - Preheat
( ) will flash.
You can now follow the instructions as
given in the programming section,
steps 3 - 5.
Programming your Quantum SmartBake - continued