Filter
Top Products
Model 500/600
3-5. WARNINGS AND
ERROR MESSAGES
The controls monitor procedure problems and system failures with warn-
ings and error codes. The display shows the warning or error code, and
an alarm sounds.
Pressing cancels most warnings and pressing any control button
stops most Error Code alarms. But there are some exceptions (see
below). The display shows the error until the situation is corrected.
WARNINGS
DISPLAY CAUSE CORRECTION
“W-1” “LOW Incoming supply voltage too low
Have voltage at plug and receptacle checked
VOLTAGE”
“W
-2” Faulty components or connections Have elements, connections, and contactors
“SLOW checked
HEAT-UP”
“W
-3” Product loaded into frypot Wait until peanut oil is at proper temperature
“WAS NOT before lights before loading product
READY”
“W-4” Frozen or too much product Do not overfill or place frozen product
“SLOW in frypot into the frypot
COOKING”
“W-5” Product loaded into frypot Wait until peanut oil is at proper temperature
“SLOW before lights before loading product.
COOKING”
“W-6” Faulty components or connections Have elements, connections, and contactors
“SLOW checked
COOKING”
“W-7” Faulty components or connections Have elements, connections, and contactors
“LOW AMPS” checked
“W-9” Product overcooked (may Discard product immediately
“DISCARD appear after a “W-6”, “SLOW
PRODUCT” COOKING” warning)
“OIL TOO Didn’t allow peanut oil to drop CANCEL button will not stop this warning;
HOT” down to current product’s setpoint once the peanut oil temperature drops to set-
temperature point temperature, the alarm automatically stops
“E-4” PC board too hot Check ventilation louvers on side of fryer for
“CPU TOO obstructions; if louvers are clear, have PC
HOT” board checked; check cooling fan if present.
205 3-11