Filter
Top Products
Model 500/600
The safety relief valve should be cleaned once a year. Figure 3-13.
DO NOT ATTEMPT TO REMOVE SAFETY VALVE
WHILE FRYER IS OPERATING, OR SEVERE BURNS
OR OTHER INJURIES WILL RESULT.
DO NOT DISASSEMBLE OR MODIFY THIS SAFETY
RELIEF VALVE. TAMPERING WITH THIS VALVE
COULD CAUSE SERIOUS INJURIES AND WILL VOID
AGENCY APPROVALS AND APPLIANCE WARRANTY.
1. Open the lid and then remove the deadweight valve cap and
deadweight.
2. Use a wrench to loosen the relief valve from the pipe elbow,
turning counterclockwise to remove.
3. Clean the inside of the pipe elbow with hot detergent.
Turn the relief valve towards the rear of the fryer when reinstalling
relief valve.
4. Immerse the safety relief valve in a soap water solution for 24
hours. Use a 1:1 dilution ratio. The valve cannot be disassembled.
It is factory preset to open at 14-1/2 pounds of pressure. If it does
not open or close, it must be replaced.
safety valve
4-3. REMOVAL AND
CLEANING
OF SAFETY RELIEF
VALVE
803 4-3
Figure 3-13