Filter
Top Products
Model 500/600
Loading Report for Previous Batch of Peanut oil
If no products have a failed to detect rate of more than 5%, the
controller shows:
“D9: LOADING”
“D9: LOOKED OK”
“D9: PREVIOUS OIL”
Otherwise, for each product that has more than 5% of loads in which
the controller failed to detect the drop point, the following message is
displayed:
“D9: PREVIOUS OIL,”
“D9: IRREGULAR”
“D9: LOADING”
“D9: FOR 6% OF”
“D9: “BRK-FIL” ( Product Name )
D 10: Non-Standard Program Items Report
The last section in the diagnostic report identifies how many
programmable settings have been altered from their original, factory
default settings.
For each of the various program modes, the controller either reports
that all settings match original values or reports N items do not match
original values. This report makes it easy to see if any cook parameters
or other settings have been changed from CFA settings.
Some programming items may have been changed from original values
under the direction of CFA corporate headquarters. In some cases, a
controller should have values that don’t match original values. A report
that “all items match original values” could actually be an indication that
something isn’t set right.
Keep in mind also that the number of such approved alterations might
be different for different versions of software.
If all product cook settings match the original, factory default values, the
controller displays the following message:
“10: ALL PROD’S”
“10: MATCH”
“10: ORIG. VALUES”
5-3. DIAGNOSTIC MODE
DETAILS (Continued)
5-24 303