Filter
Top Products
Model 500/600
5-3. DIAGNOSTIC MODE
DETAILS (Continued)
The number of “WAS NOT READY” warnings for this batch of
peanut oil is also reported. Note that this value does not yet include the
not ready warnings generated today.
“D6: BEFORE TODAY,”
“D6: COOKED”
“D6: BEFORE READY”
“D6: 8 TIMES”
“D6: ON THIS OIL”
(Press )
Finally, the controller identifies how many times the not ready warning
was generated for the previous batch of peanut oil:
“D6: LAST OIL,”
“D6: COOKED”
“D6: BEFORE READY”
“D6: 24 TIMES”
D 7: “Stopped Too Soon” Report
This section shows how many Cook Cycles were stopped early by the
user, before the cook timer had counted down to 0:00 and the
“*DONE*” indication was given. This is strictly a user error.
Cycles that are canceled after cooking for less than 30 seconds are not
counted here. For example, if a cycle is accidentally started, and the
Cook Cycle is canceled after just a few seconds, this cycle will not be
counted as a Stopped Too Soon Cycle.
Also, some allowance is given for stopping a cycle a little early. The
user can cancel the cycle up to 10 seconds early without penalty.
Otherwise, however, any cycle that was stopped with more than 10
seconds remaining (0:10) on the cook clock with be counted as a
Stopped Too Soon Cycle.
The first item displays what percent of cycles today were stopped with
more than 0:10 remaining. All products are grouped into one count.
“D7: 8% OF LOADS”
“D7: WERE STOPPED”
“D7: TOO SOON”
“D7: TODAY”
(Press )
5-20 303