Filter
Top Products
Model 500/600
3-12. CHANGING THE
FILTER ENVELOPE
(Continued)
5. Wipe the peanut oil and crumbs from the drain pan. Clean the
drain pan with soap and water. Completely rinse with hot water.
6. Unscrew the suction standpipe from the screen assembly.
7. Remove the crumb screen and clean completely with hot water.
8. Remove the filter clips and discard the filter envelope.
9. Clean the top and bottom filter screen with soap and water. Rinse
thoroughly with hot water.
Be sure that the filter screens, crumb screen, filter clips, and the
suction standpipe are completely dry before assembly of filter
envelope as water dissolves the filter paper.
10. Assemble the top filter screen to the bottom filter screen.
11. Slide the screens into a clean filter envelope.
12. Fold the corners in and then double fold the open end.
Figure 3-12.
13. Clamp the envelope in place with the two filter retaining clips.
14. Replace the crumb screen on top of the filter paper.
Screw on the suction standpipe assembly.
15. Place complete filter screen assembly and crumb basket back into
filter drain pan and slide pan back into place beneath the fryer.
16. Connect the filter union by hand. Do not use a wrench to tighten.
17. Slide the condensation drain pan back into place. The fryer is now
ready to operate.
3-24 803
Figure 3-12