Filter
Top Products
5.2 Communication Setup
5.2.3 How to Set Up the Ethernet Connection
5 - 31
1
OVERVIEW
2
SYSTEM
CONFIGURATION
3
SPECIFICATIONS
4
SCREEN
CONFIGURATION
5
OPERATING
METHOD
6
FUNCTIONS
7
INTERNAL DEVICE
INTERFACE
FUNCTION
8
TROUBLESHOOTING
APPENDICES
In a communications-ready status, the E71's RUN LED comes on and RDY LED flickers.
(5) Setting on the personal computer
Set the IP address.
(6) Communications check
(a) Ping test
When ready to communicate, execute the Ping command at the command prompt on the
Windows .
When connections are OK
C:\>ping 192. 168. 0. 2
Reply from 192. 168. 0. 2:bytes=32 time<10ms TTL=32
When connections are not good
C:\>ping 192. 168. 0. 2
Request timed out.
When the Ping test is not verified, check the connections of the cable and module, and settings,
including the IP address, for Windows .
Ping test
The Ping test can be performed using GX Developer (SW6D5C-GPPW 6.01B or
later).
Refer to the GX Developer Operating Manual for more details on the Ping test.
Refer to the following for details of the Ping test.
GX Developer Version Operating Manual
(b) Station monitoring function
For details on the station monitoring function, refer to the following manual.
GOT1000 Series Connection Manual