Filter
Top Products
5.2 Communication Setup
5.2.3 How to Set Up the Ethernet Connection
5 - 37
1
OVERVIEW
2
SYSTEM
CONFIGURATION
3
SPECIFICATIONS
4
SCREEN
CONFIGURATION
5
OPERATING
METHOD
6
FUNCTIONS
7
INTERNAL DEVICE
INTERFACE
FUNCTION
8
TROUBLESHOOTING
APPENDICES
6 When using MELDAS C6/C64
The setting items and precautions are shown below for communicating GT SoftGOT1000 to the
MELDAS C6/C64.
This section describes the system configuration to monitor the host station as shown below.
Setting items
Refer to the following for how to set the N/W No., PLC No./PC No., IP address and
port No. of the MELDAS C6/C64 and GT SoftGOT1000.
This section (7)
The following shows the procedure for communicating GT SoftGOT1000 to the MELDAS C6/C64.
(1) Before setting
(a) Precautions for monitoring
GT SoftGOT1000 cannot monitor other stations.
GT SoftGOT1000 cannot monitor CPUs on the other networks.
(b) Precautions for communication
When multiple network devices (including GT SoftGOT1000) are connected to the same
segment, the network load may increase, and the communication speed may slow down
between GT SoftGOT1000 and the PLC.
The following actions may improve the communication performance.
• Use a switching hub.
• Use the high-speed 100BASE-TX (100Mbps).
• Reduce the monitoring points of GT SoftGOT1000.
(2) Compatible models
Compatible models
FCA C6, FCA C64
<GT SoftGOT1000>
<MELDAS C6/C64>
N/W No.
PC No.
:1
:2
:192.168.0.2
:5001
<MELDAS C6/C64>
N/W No.
PC No.
:1
:1
:192.168.0.1
:5001
:1
:3
:192.168.0.3
:5001
Other station
Host
Port No.
IP address
IP address
Port No.
N/W No.
PC No.
Port No.
IP address