Filter
Top Products
8 - 3
8.1 Error Message
(Continued to next page)
Error message Definition and cause Corrective action
Path name is too long.
Save the GT Designer2 under too many
directory levels.
In Option setting, set the project of GT
Designer2 again.
GOT type of the project is different from the
one specified in the GT SoftGOT1000.
[Project data setting]
GOT type : #####(###x###)
PLC type : #####
[GT SoftGOT1000 setting]
Resolution : ###x###
Connection : #####(#####)
The GOT type set in the project is different
from the GOT type specified in GT
SoftGOT1000.
Make correction so that the GOT type of the
project created on GT Designer2 is the same
as the GOT type of GT SoftGOT1000.
GOT type (Resolution) of the project is
different from the one specified in the GT
SoftGOT1000.
[Project data setting]
GOT type : #####(###x###)
PLC type : #####
[GT SoftGOT1000 setting]
Resolution : ###x###
Connection : #####(#####)
The GOT type (Resolution) set in the project
is different from the GOT type (Resolution)
specified in GT SoftGOT1000.
Make correction so that the GOT type
(Resolution) of the project created on GT
Designer2 is the same as the GOT type
(Resolution) of GT SoftGOT1000.
PLC type of the project is different from the
one specified in the GT SoftGOT1000.
[Project data setting]
GOT type : #####(###x###)
PLC type : #####
[GT SoftGOT1000 setting]
Resolution : ###x###
Connection : #####(#####)
The PLC type set in the project is different
from that in GT SoftGOT1000.
Make correction so that the PLC type of the
project created on GT Designer2 is the same
as the CPU type of GT SoftGOT1000.
Manual file cannot be found.
Please install manuals.
• GT Manual 1000 is not installed.
• GT Manual 1000 is not installed correctly.
After uninstalling GT Manual, reinstall it.
Cannot stop monitoring.
Close the dialog on monitor screen and retry.
Since the message such as "This function
cannot be used now" was displayed on the
screen, GT SoftGOT1000 could not be exit
correctly.
After selecting in the dialog box to erase
the on-screen message, exit from GT
SoftGOT1000 again.
There was the other internal cause than the
above that did not allow to exit from the
software.
After selecting in the dialog box, wait for
some time and exit from GT SoftGOT1000
again.
Fail in the delete of resource data.
• Please close resource data if it is opened.
• Check the file access privilege.
Failed in erasing resource data after loading
screen data.
• If there is resource data opened by another
software, close that file.
• Check the file access privilege.
Initialization for reading failed.
Execute one of the following operations.
• Close the dialog if it is displayed.
• Switching to offline mode may have been
failed.
Wait for several seconds and retry the
operation.
Since the message such as "This function
cannot be used now" was displayed on the
screen, this funciton can not be loaded.
After selecting in the dialog box to erase
the on-screen message, re-load the function.
Waiting for completion of internal process. re-load the function after a few minutes.
OK
OK
OK