Filter
Top Products
HOT DRINK SETUP/PROGRAMMING GUIDE
6700001 Page - C7 November, 2002
APPENDIX C. DEX/UCS INTERFACE OPERATION
APPENDIX C. DEX/UCS INTERFACE OPERATION
Connect your portable data collection device (PDCD) to the harness hanging inside the
monetary door, and operate it per its instructions.
SELECT DATA TRANSFER METHOD:
1. Press
. The display shows: ENTER CODE . You must enter the four-
digit supervisor code within 6 seconds to gain access.
NOTE
A new machine has a factory-set supervisor code of 0000.
When you have entered the right code, you will hear two beeps and see
SUPERVISOR in the display.
2. Press until the display shows DEX.CLR ON or DEX.CLR OFF.
DEX.CLR ON = Data will be cleared after collection is complete.
DEX.CLR OFF = Data will remain in merchandiser memory after collec-
tion is complete.
3. Press to switch between the two options.
4. Press to exit.
This procedure does not need to be repeated unless you desire to change the data
transfer option. However, it might be prudent to check the setting prior to download to
ensure unintentional clearing of data.
DOWNLOAD DATA:
1. Press . The display shows DEX.MODE while data is being transferred.