Filter
Top Products
HOT DRINK SETUP/PROGRAMMING GUIDE
6700001 Page - 5 November, 2002
2. Mount the Base Plate:
WARNING
DO NOT MOVE THE CABINET WHILE HEX
HEAD SCREWS AND/OR CARRIAGE
BOLTS ARE LOOSENED. THE CABINET
WOULD BECOME UNSTABLE AND LIKE-
LY TO TIP AND CAUSE INJURY.
a. Remove the pail(s) from the inside of the merchandiser.
b. Remove the floor liner from the inside of the merchandiser.
c. Remove the two caps as shown.
d. Loosen the left leg assembly carriage bolts and nuts to allow mounting a base plate
bracket.
e. Secure one of the base plate brackets to the leg assembly using the two carriage
bolt. Tighten the carriage bolts and nuts.
f. Loosen the right leg assembly hex head screws to allow mounting the other base
plate bracket.
g. Secure the other base plate bracket to the right leg assembly using the two hex
head screws. Tighten the hex head screws.
h. Insert the short arms of the slides into the hinged tabs of the base plate. Position
the slide so the notch near the short arm is on the bottom side.
i. Insert the long arms of the slides into the base plate brackets.
j. Insert and secure a cotter pin through the hole in the back of each of the slides.
k. Push the base plate toward the merchandiser cabinet. The front tabs of the base
plate brackets should seat in the notches in the long arms of the slides.
l. Replace the caps, liner, and pail(s) removed previously.
CAPS
BASE PLATE BRACKET
COTTER PIN
B
ASE PLATE
ASSEMBLY
SLIDE - L.H.
SLIDE - R.H.