Filter
Top Products
HOT DRINK SETUP/PROGRAMMING GUIDE
6700001 Page - 3 November, 2002
II. POSITIONING THE
MERCHANDISER
You can position this merchandiser anywhere in a bank of machines. It can even be
placed on the end flush against a side wall. Be sure you leave enough room in front
of the merchandiser for the door to move freely.
BE SURE THE REAR OF THE MERCHANDISER IS AT LEAST 6" AWAY
FROM THE WALL. THIS WILL ALLOW WARM MOIST AIR TO BE VENTED
OUT OF THE MACHINE'S INTERIOR.
WARNING:
THIS MACHINE IS ONLY RATED FOR INSTALLATION IN AN
INDOOR LOCATION.
III. CONNECTING EVERYTHING
1. Connect the Merchandiser to the Water Supply:
a. You will need the following:
• A coil of copper tubing with outside diameter of 3/8 inch (9.5 mm) or greater.
The appropriate plastic tubing may be substituted. The tubing must be long
enough to reach from the water source to your machine with enough left over
to form a loop about 2 feet (60 cm) in diameter. This will allow you to move the
machine without straining the water line.
• A 3/8 inch (9.5 mm) flare fitting.
b. Connect the merchandiser to your water supply.
2. Connect the Merchandiser to the Electrical Power Supply:
Power inside the merchandiser is controlled by the main power switch, located on the
power panel.
a. Make sure the main power switch is OFF.
b. Connect the merchandiser’s power cord to your wall outlet.