Filter
Top Products
HOT DRINK SETUP/PROGRAMMING GUIDE
6700001 Page - 13 November, 2002
e. The following figure shows a coin mechanism, bill validator, and card reader
connected to one another via an MDB. Some monetary configurations may not
include all of these devices. Connect your coin mechanism as shown:
f. Turn ON the main power switch. Select MDB MECH in the SELECT COIN
MECHANISM AND OPTIONS procedure on page 2-11. Press until the
standby message is displayed, then press . Insert enough coins through
the coin slot into the coin tubes to more than cover the empty sensor. Insert coins
one at a time and ensure they lay flat in the tubes. The amount of coins you insert
is internally recorded.
g. Payout about 6 coins to ensure proper loading.
h. Finish inserting coins through the coin slot to fill all the tubes with coins.
i. Visually check the coin tubes to make sure coins are not shingled.