Filter
Top Products
HOT DRINK SETUP/PROGRAMMING GUIDE
November, 2002 Page - 12 6700001
6. Set Up and Load the Coin Mechanism
Standard Coin Mechanism
Setting the Quarter Switch. If your coin mechanism is not a MARS TRC 6000, skip
this procedure and begin LOADING THE COIN MECHANISM.
a. Flip down the front of the coin
mechanism as shown, and set the quarter switch.
Load the Coin Mechanism.
a. Open the cabinet door and the monetary door.
b. Insert coins into their respective tubes until each tube has been filled.
c. Inspect the tubes for shingled coins and correct if necessary.
MDB Coin Mechanism
Install the coin mechanism as follows:
WARNING
Make sure the main power switch is turned OFF before you
work on the merchandiser. Failure to do so could result in
death or injury.
a. Turn OFF the main power switch. Refer to the instructions provided with the coin
mechanism and remove the coin validator assembly.
b. Loosen the coin mechanism mounting screws on the merchandiser so they stand
off about 1/8" (0.3 cm).
c. Position the coin mechanism so the three keyed holes fit over the mounting screws.
Pull down on the coin mechanism to seat the screws in the keyways.
d. Tighten the mounting screws and reinstall the coin validator assembly.