Filter
Top Products
HOT DRINK SETUP/PROGRAMMING GUIDE
6700001 Page - 9 November, 2002
4. Load the Optional Filter Paper:
a. Be sure the main power switch is in the OFF position.
b. Remove the cup station and grounds bucket.
c. Remove the paper holder cover by turning the fastener a quarter turn to the left.
d. Insert a roll of paper into the paper holder. Route the free end of the paper to the
brewer as shown.
e. Replace the cover on the paper holder. Secure it by turning the fastener a quarter
turn to the right.
f. Feed paper over swing arm assembly and underneath pinion gear shaft.
g. Feed paper through the paper guides.
h. Raise the basket housing assembly and feed paper over the lip of the paper
mechanism housing.
PAPER
H
OLDER
PAPER
ROLL
COVER
FASTENE
R
TO BREWER
NOTE
It may be necessary to reach underneath the brewer between
the paper mechanism housing and swing arm assembly to
push paper over the lip of the paper mechanism housing.
PAPER
GUIDES
PINION GEAR SHAFT
BASKET HOUSIN
G
ASSEMBLY
SWING ARM
ASSEMBLY
L
IP OF PAPER MECHANISM HOUSING
PAPER MECHANISM HOUSING
(CONTINUED)