Filter
Top Products
HOT DRINK SETUP/PROGRAMMING GUIDE
November, 2002 Page - 14 6700001
FILL
CANISTER
C
ANISTER
C
AP
7. Fill the Tank:
a. Make sure the main power switch is ON.
b. Turn on the water at its source.
c. On the maintenance keypad, press
, then press until the display
shows TANK.FILL.
d. Press . You should hear water running into the tank, and the display will
show
FILLING. The water will run until either the tank is full or 12 minutes go by,
whichever happens first.
NOTE
The inlet water valve only stays open for 12 minutes at a time.
This is a safety feature to prevent water from running into a
leaky system and making a mess. It is possible for your tank
to take longer than 12 minutes to fill if your location has low
water pressure. To be on the safe side, check for leaks if the
water runs a long time. If you find none, everything is normal;
you just have low water pressure.
e. When you hear the water stop running, repeat steps 3 and 4. Under normal
circumstances, nothing will happen. If water starts running and the display shows
FILLING again, your pressure is low and it is just taking a long time to fill the tank.
Repeat this step if necessary to be sure your water tank is full.
8. Fill the Canisters:
Open the lid as shown, and carefully pour the appropriate product into the canister.
Repeat for all canisters in the machine.