Filter
Top Products
HOT DRINK SETUP/PROGRAMMING GUIDE
6700001 Page - 25 November, 2002
The Function Keys
The FUNCTION keys on the service keypad can be used for up to three
things:
THE NUMBER
YOU MIGHT BE ASKED TO
ENTER
A NUMERICAL VAL-
UE. YOU CAN DO THIS
IN
TWO WAYS: PRESSING
THIS
KEY IS THE SAME AS
PRESSING
THE "5" ON
THE PRIMARY PUR-
POSE
THIS IS THE MAIN JOB OF
THE
KEY. FROM THE
STANDBY
MESSAGE, IT WILL
ALLOW
YOU TO ENTER A
PROGRAMMING
MODE. IN
THE SECONDARY
PURPOSE THIS IS THE
KEY
'S "SECOND JOB". THIS
KEY
CAN BE USED TO DELETE
A
CHARACTER WHEN YOU
ARE
EDITING CUSTOM MES-
The MOVEMENT keys on the control panel let you move inside a mode,
and back and forth between modes. To see how these keys let you
move around, study the flow diagram on the next page.
Other Keys
The up and down arrow keys are your "legs", which let
you move up and down the list of tasks. These keys are
what let you continue from one step to the next in
programming procedures.
This is your "activate" or "choose" key. It "opens a door" to
additional information and lets you begin a programming task
once you are inside of a mode. Sometimes, it is used as a
toggle switch to show you your choices during a programming
task.
This is your "end" key. Pressing it one or more times will move
you back to the start of the mode, or all the way back to the
standby message.
This key lets you start an action, such as a test.