Filter
Top Products
HOT DRINK SETUP/PROGRAMMING GUIDE
November, 2002 Page - 78 6700001
EDIT CUSTOM MESSAGES
1. Press , and press until the display shows EDIT
MSG'S. Press the number of the message you want to edit. MES-
SAGE X
is displayed (X represents the message number you
pressed).
2. Press . The message text is displayed with the first char-
acter flashing.
3. To view the message, press
. The message scrolls across
the display. To stop the scrolling, press .
4. When the character you want to change is flashing, either enter it
directly, or use and to step through the character set
until the desired character is displayed. Use the arrow keys to high-
light different characters. See the section on the next page for an
explanation of special keys and the character set.
SHORTCUT
Instead of stepping through the whole character set
to enter a letter that is not on your keypad, enter one
close to the one you want, then step to it. Example:
If you want to enter an L, first press J on the selec-
tion switch panel.
Then press twice. Your L should now be
displayed.
THE END OF MESSAGE CHARACTER
This is the most important character in your message, because it
tells the machine when the message is ended. If you don't use this
character, your message will be followed by a bunch of zeros. This
character can be selected either from the character set or by a direct
key entry (see the next page).