Support User Manuals

Agilent Technologies Agilent 86120C Ventilation Hood User Manual

Open as PDF

of 294

3-44

Programming

Lists of Commands

CALCulate1 (CALC1) Subsystem

:CALCulate1:DATA? Queries the uncorrected frequency-spectrum data of the

input signal.

S

:CALCulate1:TRANsform:FREQuency:POINts? Sets and queries the number of points in the data set. S

CALCulate2 (CALC2) Subsystem

:CALCulate2:DATA? Queries the corrected frequency-spectrum data of the

input signal.

S

:CALCulate2:PEXCursion Sets the peak excursion limit. I

:CALCulate2:POINts? Queries the number of points in the data set. I

:CALCulate2:PTHReshold Sets the peak threshold limit. I

:CALCulate2:PWAVerage[:STATe]? Places the instrument in the average-wavelength mode.

Data queries return the power-weighted average

frequency, wavelength, or wavenumber or total power.

I

:CALCulate2:WLIMit[:STATe] Turns wavelength limiting on and off. I

:CALCulate2:WLIMit:STARt:FREQuency Sets the starting frequency for the wavelength limit range. I

:CALCulate2:WLIMit:STARt[:WAVelength] Sets the starting wavelength for the wavelength limit

range.

I

:CALCulate2:WLIMit:STARt:WNUMber Sets the starting wavenumber for the wavelength limit

range.

I

:CALCulate2:WLIMit:STOP:FREQuency Sets the stopping frequency for the wavelength limit

range.

I

:CALCulate2:WLIMit:STOP[:WAVelength] Sets the stopping wavelength for the wavelength limit

range.

I

:CALCulate2:WLIMit:STOP:WNUMber Sets the stopping wavenumber for the wavelength limit

range.

I

CALCulate3 (CALC3) Subsystem

:CALCulate3:ASNR:CLEar Resets and restarts the signal-to-noise ratio averaging. I

:CALCulate3:ASNR:COUNt Sets the number of measurements to average the signal-

to-noise ratio.

I

:CALCulate3:ASNR:[:STATe] Turns signal-to-noise ratio averaging mode on and off. I

:CALCulate3:DATA? Queries the data resulting from delta, drift, and signal-to-

noise measurements.

S

:CALCulate3:DELTa:POWer[:STATe] Turns the delta power measurement mode on and off. I

:CALCulate3:DELTa:REFerence:FREQuency Selects the signal to be used as the reference for the

DELTa calculations.

I

:CALCulate3:DELTa:REFerence:POWer? Queries the power level of the reference signal. I

Table 3-10. Programming Commands (2 of 5)

Command Description Code

Codes: S indicates a standard SCPI command. I indicates an instrument specific command.

previous next