Filter
Top Products
3-46
Programming
Lists of Commands
:CALCulate3:FPERot:POWer:[WAVelength]? Queries the power wavelength of the selected modes. I
:CALCulate3:FPERot:POWer:FREQuency? Queries the power frequency of the selected modes. I
:CALCulate3:FPERot:POWer:WNUMber? Queries the power wavenumber of the selected modes. I
:CALCulate3:FPERot:SIGMa:[WAVelength]? Queries the sigma wavelength of the selected modes. I
:CALCulate3:FPERot:SIGMa:FREQuency? Queries the sigma frequency of the selected modes. I
:CALCulate3:FPERot:SIGMa:WNUMber? Queries the sigma wavenumber of the selected modes. I
:CALCulate3:POINts? Queries the number of points in the data set. I
:CALCulate3:PRESet Turns off any CALCulate3 calculation that is on. I
:CALCulate3:SNR:AUTO Selects the internal or externally entered frequency value
for the noise measurement reference in the SNR
calculation.
I
:CALCulate3:SNR:REFerence:FREQuency Sets the frequency used for the noise measurement
reference in the SNR calculation.
I
:CALCulate3:SNR:REFerence[:WAVelength] Sets the wavelength used for the noise measurement
reference in the SNR calculation.
I
:CALCulate3:SNR:REFerence:WNUMber Sets the wave number used for the noise measurement
reference in the SNR calculation.
I
:CALCulate3:SNR[:STATe] Turns the SNR calculation on and off. I
DISPlay Subsystem
:DISPlay:MARKer:MAXimum Sets the marker to the signal with the largest power. I
:DISPlay:MARKer:MAXimum:LEFT Moves marker to signal with the next lower wavelength or
frequency.
I
:DISPlay:MARKer:MAXimum:NEXT Moves the marker to the signal with the closest power
level just below the power level of the signal at the current
marker position.
I
:DISPlay:MARKer:MAXimum:PREVious Moves the marker to the signal with the closest power
level just above the power level of the signal at the current
marker position.
I
:DISPlay:MARKer:MAXimum:RIGHt Moves marker to the next higher wavelength or frequency. I
:DISPlay[:WINDow]:GRAPhics:STATe Turns the instrument display of the power bars on and off. S
HCOPy Subsystem
:HCOPy:IMMediate Starts a printout. S
SENSe Subsystem
:SENSe:CORRection:DEVice Configures wavelength measurements for narrowband or
wideband devices.
I
Table 3-10. Programming Commands (4 of 5)
Command Description Code
Codes: S indicates a standard SCPI command. I indicates an instrument specific command.