Filter
Top Products
1-7
Getting Started
Step 4. Turn on the Agilent 86120C
Step 4. Turn on the Agilent 86120C
1 Press the front-panel LINE key. After approximately 20 seconds, the
display should look similar to the figure below.
The front-panel LINE switch disconnects the mains circuits from the
mains supply after the EMC filters and before other parts of the instru-
ment.
2 If the Agilent 86120C fails to turn on properly, consider the following
possibilities:
• Is the line fuse good?
• Does the line socket have power?
• Is it plugged into the proper ac power source?
If the instrument still fails, return it to Agilent Technologies for repair.
Refer to “Returning the Instrument for Service” on page 1-11.
Instrument firmware version
When the instrument is first turned on, the display briefly shows the instrument’s
firmware version number. In the unlikely event that you have a problem with the
Agilent 86120C, you may need to indicate this number when communicating with
Agilent Technologies.