Filter
Top Products
4-34
Programming Commands
CALCulate2 Subsystem
POINts?
Queries the number of points in the data set.
Syntax
:CALCulate2:POINts?
Attribute
Summary
Preset State: unaffected
*RST State: unaffected
SCPI Compliance: instrument specific
Query Only
Description This is the number of points that will be returned by the
CALC2:DATA? query.
Query Response For example, if six laser lines are located:
+6
PTHReshold
Sets the peak threshold limit used by the instrument to determine
valid laser line peaks.
Syntax
:CALCulate2:PTHReshold{?| {<integer> | MINimum | MAXimum | DEFault}}
<integer> represents logarithmic units in dB. Valid range is 0 to 40.
Constant
Value
MINimum 0 dB
MAXimum 40 dB
Non-sequential command
Always use an *OPC? query or a *WAI command to ensure that this command has
the time to complete before sending any more commands to the instrument. Refer
to “Always force the Agilent 86120C to wait for non-sequential commands” on
page 3-12 for more information.