Filter
Top Products
3-4
Programming
Addressing and Initializing the Instrument
Notice in the example above, that the commands are sent to an instru-
ment address of 720. This indicates address 20 on an interface with
select code 7. Pressing the green Preset key does not change the GPIB
address.
Set single acquisition mode
An advantage of using the *RST command is that it sets the
Agilent 86120C into the single measurement acquisition mode. Because
the READ and MEASure data queries expect this mode, their proper
operation is ensured.
To change the GPIB address
1 Press the Setup key.
2 Press MORE twice, then GPIB.
3 Use the and softkeys to change the GPIB address.
4 Press RETURN.