Filter
Top Products
4-9
Programming Commands
Common Commands
*SAV
This command saves an instrument state.
Syntax
*SAV <integer>
<integer> range is 1 to 4.
Description The following constitutes an instrument state: single/continuous mea-
surement mode, power bar on/off, vacuum/STD air mode, normal/fast
update, list by WL, list by Pwr, peak, or avg display mode, frequency
units, power units, elevation, peak excursion, peak threshold, power
Number of uncorrected data points 15,047
Delta Measurements:
∆ power
off
∆ wavelength
off
∆ wavelength and power
off
reference signal position 1270 nm
Drift measurements off
Signal-to-Noise Measurements:
measurement off
wavelength reference auto
reference (user) wavelength 1550 nm in vacuum
number of averages (count) 100
GPIB address not affected
Power-bar display on
Table 4-15. Conditions Set by *RST Reset (2 of 2)
Item Setting