Filter
Top Products
4-73
Programming Commands
CALCulate3 Subsystem
SNR[:STATe]
Turns the signal-to-noise calculation on and off.
Syntax
:CALCulate3:SNR[:STATe]{?| {ON | OFF | 1 | 0}}
Attribute
Summary
Preset State: off
*RST State: off
SCPI Compliance: instrument specific
Note
Only one STATe command can be turned on at any one time. Attempting to turn
more than one state on at a time results in a “–221 Settings Conflict” error. Refer
to “Measure delta, drift, and signal-to-noise” on page 3-14 for additional informa-
tion on selecting measurements.