4-41
Programming Commands
CALCulate2 Subsystem
WLIMit:STOP:FREQuency
Sets the stopping frequency for the wavelength limit range.
Syntax
:CALCulate2:WLIMit:STOP:FREQuency {?|{<real> | MINimum | MAXimum }}
<real> is a frequency value that is within the following limits:
Constant
Description
MINimum start wavelength limit
MAXimum 236.0571 THz (1270 nm)
Attribute
Summary
Non-sequential command
Preset State: 236.0571 THz
*RST State: 236.0571 THz
SCPI Compliance: instrument specific
Description This command sets the stopping range for the wavelength limit. The
default units for the <real> parameter are Hz. The stop frequency
value must be greater than or equal to the start frequency value or the
stop frequency will be clipped to the start frequency and a “Data out
of range” error will be generated.
Non-sequential command
Always use an *OPC? query or a *WAI command to ensure that this command has
the time to complete before sending any more commands to the instrument. Refer
to “Always force the Agilent 86120C to wait for non-sequential commands” on
page 3-12 for more information.
