Filter
Top Products
4-57
Programming Commands
CALCulate3 Subsystem
DRIFt:MAXimum[:STATe]
Sets the drift calculation to return the maximum power and frequency
values measured.
Syntax
:CALCulate3:DRIFt:MAXimum[:STATe]{?| {ON | OFF | 1 | 0}}
Attribute
Summary
Preset State: off
*RST State: off
SCPI Compliance: instrument specific
Description Use the CALC3:DRIF:PRES command to turn off all the drift states
before turning on this state. The CALC3:DATA? query returns the max-
imum power and frequency.
Note
Only one STATe command can be turned on at any one time. Attempting to turn
more than one state on at a time results in a “–221 Settings Conflict” error. Refer
to “Measure delta, drift, and signal-to-noise” on page 3-14 for additional informa-
tion on selecting measurements.